Product ID:728-011 MIL P 15328C
MSDS Date:01/01/1985
FSC:8030
NIIN:00-165-8577
MSDS Number: BDDYW

AMERON PROTECTIVE COATINGS

201 NORTH BERRY STREET
BREA, CA 92622-1020
US

Emergency Phone: 714-529-1951

Info Phone: 714-529-1951

Cage: 0Y2E4

AMERON PROTECTIVE COATINGS

1020 BREA, CA 92622-1020 US

Telephone: 714-529-1951

Cage: 0Y2E4

ISOPROPANOL (ISOPROPYL ALCOHOL), 2-PROPANOL, DIMETHYL

CAS: 67-63-0

RTECS: NT8050000

Fraction By Weight: 65.2%

OSHA PEL 400 PPM

ACGIH TLV: 400 PPM

PHOSPHORIC ACID *97-3*

CAS: 7664-38-2

RTECS: TB6300000

Fraction By Weight: 18.4%

OSHA PEL 1 MG/CUM

ACGIH TLV: 1 MG/CUM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: ANESTHETIC. MAY CAUSE
IRRITATION TO THE RESPIRATORY TRACT. NERVOUS SYSTEM DEPRESSION.
SKIN/EYES: PRIMARY IRRITANT.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, HEADACHE, DIZZINESS, STAGGERING
GAIT, CONFUSION, UNCONSCIOUSNESS, COMA

First Aid:SKIN/EYES: FLUSH W/PLENTY OF WATER. INHALATION: REMOVE TO
FRESH AIR. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Flash Point Method:TCC
Flash Point:59F
Lower Limits:2.5
Extinguishing Media:SMALL FIRES: CO2, DRY CHEMICAL. LARGE FIRES:
POLYMER FOAM
Fire Fighting Procedures:USE SELF-CONTAINED BREATHING APPARATUS.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS EXPOSED TO HEAT MAY
EXPLODE DUE TO PRESSURE BUILD-UP.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. AVOID
BREATHING VAPORS. VENTILATE AREA. REMOVE W/INERT ABSORBENT &
NON-SPARKING TOOLS.

Handling and Storage Precautions:DON'T STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDINGS DESIGNED & PROTECTED FOR STORAGE OF
FLAMMABLE LIQUIDS.
Other Precautions:DON'T TAKE INTERNALLY. CONTAINERS SHOULD BE GROUNDED
WHEN POURING. AVOID FREE FALL OF LIQUID IN EXCESS OF A FEW INCHES.
DON'T WELD, FLAME CUT/BRAZE W/O APPROVED RESPIRATOR.

Respiratory Protection:OUTDOOR/OPEN AREA: APPROVED MECHANICAL FILTER
RESPIRATOR TO REMOVE AIR BORNE PARTICLES OF OVERSPRAY. RESTRICTED
AREA: APPROVED CHEMICAL-MECHANICAL FILTERS DESIGNED TO REMOVE
GAS/VAPORS. CONFINED AREA: APPROVED AIR TYPE RESPIRATORS/HOODS.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST: TO KEEP HAZARDOUS
INGREDIENTS BELOW ACCEPTABLE LIMITS.
Protective Gloves:REQUIRED
Eye Protection:SAFETY EYEWEAR W/SPLASH GUARDS
Other Protective Equipment:PREVENT PROLONGED SKIN CONTACT TO
CONTAMINATED CLOTHING.
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health

HCC:F3
Boiling Pt:B.P. Text:175-208F
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:87.7

Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:FIRES, HEAT, HOT SURFACES,
ELECTRICAL/STATIC/FRICTIONAL SPARKS & OTHER IGNITION SOURCES

Waste Disposal Methods:DISPOSE IN ACCORDANCE W/LOCAL, STATE & FEDERAL
REGULATIONS. INCINERATE IN APPROVED FACILITY. DON'T INCINERATE
CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.